Unit Usp 1020d Instruktsiia May 2026

In memory mode, press and hold MEM and SET simultaneously until "CL" appears on the screen. ⚠️ Error Codes & Troubleshooting Er 1 Sensor is abnormal Check cuff connection and try again. Er 2 Pulse signal not detected Ensure cuff is snug and you remain still. Er 3 Measurement result error Relax for 2 minutes and retake the test. Er 4 Cuff is too loose or leaking Re-wrap the cuff tightly. Low Battery Batteries are drained Replace all 4 batteries with fresh ones. 🧼 Maintenance & Storage Clean the monitor with a soft, dry cloth. Never submerge the cuff or monitor in water. Store in a cool, dry place away from direct sunlight.

Once the measurement is complete, the cuff deflates, and the screen displays: Systolic (top number) DIA: Diastolic (bottom number) PULSE: Heart rate per minute

Press the SET button while the device is off to toggle between User 1 and User 2. unit usp 1020d instruktsiia

With the device OFF, press and hold the button for 3 seconds.

Press the MEM button. It will first show the average of the last 3 readings. Press it again to scroll through previous entries. In memory mode, press and hold MEM and

Do not smoke, drink caffeine, or exercise for 30 minutes prior.

The will flash. Use the MEM button to change the value, then press SET to confirm. Repeat this process for Month , Day , Hour , and Minute . Preparing for Measurement Er 3 Measurement result error Relax for 2

Before taking your first measurement, ensure the device is configured correctly. 1. Power Supply